No controllers yet. Power one up and enter this server's address on its setup hotspot page.
pH--
EC mS/cm--
Water °C--
Level--
| Pump | State | Today | Run | |
|---|---|---|---|---|
Runs are checked by the controller: maximum run, daily cap, low water, leak.
Name
pH probe
- Rinse the probe, shake it dry.
- Put it in a buffer and wait until the voltage is stable.
- Save the point. Do the mid buffer (6.86 or 7.00) and at least one more.
Live: -- V
EC probe
- Rinse, then put the probe in the standard solution.
- Wait for a stable reading, enter the standard's value.
Live: -- V
mS/cm
Level
Record the reading with the reservoir empty, then full.
Live raw: --
Pump flow
Run the pump into a measuring cup, then enter what it delivered.
s
The server alerts (event log and push) when a reading stays outside these limits. Leave a box empty to turn that alert off.